TILTON – OT-185 7.25 OT-II Metallic Racing Clutches for Pot Clutch Flywheel Type

Designed primarily for road racing, circle track, open wheel and formula applications, Tiltons 7.25 OT-II metallic racing clutches offer the low moment-of-inertia, high torque capacity and reliability necessary for the most demanding racing applications. These features have made metallic clutches the most common clutch type used in road racing and circle track racing. Metallic clutches are not recommended for street use.

Applications

• Road Racing
• Circle Track
• Open Wheel
• Formula

Design

Open, one-piece clutch cover design provides lower operating temperature, high strength and minimal deflection for quick shifting.

Engineering

Chrome vanadium diaphragm springs and an engineered pressure plate geometry provide a high clamp load-to-wear ratio, low release load, and quick shifting.

Materials

High-strength steel is used in both the pressure plates and the floater plates.

Toughness

.104-thick friction disc withstands elevated temperatures while providing low inertia and excellent wear resistance.

Operation

Hardened steel thrust buttons provide a smooth and durable surface for pressure and floater plates.

Testing

Every Tilton OT clutch is dynamically balanced to ensure the highest level of performance.

Quality Assurance

Each OT clutch is individually inspected for proper assembly and balance, and initialed by the quality personnel as confirmation.

1-Plate Specifications:
Weight**: 5.1 lbs/2.3 kg
M.O.I.**: 44.1 lb-in2/.0130 kg-m2

2-Plate Specifications:
Weight**: 7.5 lbs/3.4 kg
M.O.I.**: 66.3 lb-in2/.0195 kg-m2

3-Plate Specifications:
Weight**: 9.9 lbs/4.5 kg
M.O.I.**: 87.6 lb-in2/.0258 kg-m2

Tilton offers two different styles of every clutch configuration: one designed to be compatible with a step-type flywheel, and another for pot-type (no-step) flywheels. Step flywheels have a .100 step for contact with the friction material of the clutch, so clutches made for this application will have a .100 height difference between the bottom friction disc and the end of the clutch cover legs (the mounting points). Pot flywheels dont have this step, so the friction disc and clutch cover legs will be flush on clutches designed for them.

Tiltons 7.25 metallic clutches are available with either a High Ratio or Ultra-High Ratio pressure plate. High Ratio pressure plates offer high clamp load over a wide wear range, while Ultra-High Ratio pressure plates provide 20% more clamp load and diaphragm spring travel (modulation). As seen on the graph below, the clamp load (or torque capacity) of the High Ratio pressure plate is relatively flat until .030 (76mm) of wear; Ultra-High Ratio pressure plates offer a higher initial clamp load ata fasterwear rate.

• Standard pressure plate ratio for 7.25 metallic clutches
• Short release travel for quick engagement and shifting
• Flat clamp load curve for longest wear range

• 20% more release travel than High Ratio for improved modulation
• 20% more clamp load than High Ratio for higher peak torque capacity
• Clamp load reduced more quickly with wear than High Ratio

INSTALLATION INSTRUCTIONS

INSTALLATION DRAWING

3D MODEL

CATALOG PAGES