Action Clutch’s Stage 5 (2MS) clutch kit allows for maximum performance of mid ranged powered vehicles. Our heavy-duty pressure plate is designed with dual clamp load and reinforced drive straps, creating an extremely durable system that you can rely on. This MIBA Sprung Ceramic kit features a 4 and 6 MIBA Ceramic puck configuration, allowing you to choose the aggressive or milder set up depending on your preference. With lightning-fast engagement and minimal clutch chatter after proper break-in, this clutch kit is ideal for harnessing all the power and performance you need out of your vehicle without compromising on reliability or longevity.

At Action Clutch, safety is our top priority. We understand how catastrophic engine or transmission damage can be caused by springs popping out which is why we use our patented, fully enclosed spring retainers to keep your investment protected at all times. Every kit is quality checked by one of our experienced engineers (with over 60 years of collective experience) and signed off as safe before being released as a finished product. This gives you peace of mind knowing that your Action Clutch will perform consistently every time.

200% INCREASED HOLDING CAPACITY OVER FACTORY KIT*
RACE APPLICATIONS / HEAVY TRACK USE

*Ceramic based clutch discs intend to increase the holding capacity and durability of the clutch as opposed to an increased life expectancy. Using a ceramic based material for easy street driving may contribute to premature wear of the clutch kit due to the harsher engagement and because of the higher tendency to slip the clutch in street driving. Ceramic discs are never recommended for stock or lightly modified vehicle applications.

*Increase in holding capacity is rated in Crank Torque, not Wheel Torque

Please contact us at [email protected] to inquire on current inventory. If out of stock, please allow 4-8 weeks for fulfillment.

Whats Included

• Sprung MIBA Ceramic 6 Puck Disc
• Dual Clamp Load HD Pressure Plate
• Pilot Bearing / Bushing (when applicable)
• Clutch Alignment Tool
• Conventional Release Bearing

Break-in Requirements
500 street miles / Keep RPMs under 4500, no more than half-throttle, no boost (if applicable).
Proper break-in is required in order to retain product warranty, ensure longevity and holding capacity.

SFI Spec 1.1 Replacement Flywheels and Clutch Assemblies

California Residents: Prop 65 WARNING:This product MAY contain chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. Wash hands after handling. For more information, visit www.p65warnings.ca.gov