Eventuri Audi Turbo Flange

Info

The final criteria was to minimize the conduction of heat into the airflow. The stock inlet is directly connected to the turbo and so immediately conducts heat as the turbo spools. Our system uses a machined flange which connects to the turbo and then a silicon coupler with an integrated thermal spacer to keep the carbon elbow from having direct contact with the turbo. This barrier coupled with the low through-thickness thermal conductivity of carbon fiber results in less heat being transferred to the airflow.

Eventuri’s Warranty

For information on Eventuri’s warranty terms and conditions, please click here.

Purchase Disclaimer: You are hereby informed and warned to check your local, state, and federal laws before buying and installing these or any aftermarket parts to be sure whether usage is in violation. All installation-risk and use-risk is borne by the end-user and installer of these parts. Bolt Motorsports does not condone the use of emission defeat devices for any vehicles used on public streets or roadways. Bolt Motorsports will not tamper, remove, disable, or bypass emissions equipment on a motor vehicle in accordance with 40 CFR Section 86.1854.12(a)(3), Clean Air Act 40 CFR 1068.101(b). This includes software, known as tunes, that reprogram a motor vehicles electronic control module to alter engine performance and enable the removal of filters, catalysts, and other critical emissions controls. In accordance with local laws and regulations, Bolt Motorsports will not ship parts to locations where usage or installation of said part would be in violation of the aforementioned acts.