**NOTE: Immediately after installing the brake pads, the pad and rotor aren’t hot, so braking force is reduced until it reaches temperature. Please allow sufficient time for break-in.**This brake pad has significantly improved the fade resistance of the HC series, which covers everything from city driving to sports driving, and also has the fighting power for circuit driving. In addition to stable effectiveness at high temperatures, this model also achieves pedal control by pedal pressure in line with the characteristics of recent electronic control devices and ABS intervention.Material: Super Graphite MetallicApplicable Rotor Temperature: 50-700 Degrees CelsiusFriction Coefficient: 0.39-0.49mu**Reliably Removes Dust Generated By Intense Friction**When the substances contained in the friction material of the brake pads burn due to high temperatures, gas is generated, and the gap between the pads and the rotor interferes with the effectiveness of the brakes. This is called the fade phenomenon. The slits located in the center of the brake pads efficiently discharge gas and pad residue, maintaining stable braking force.\*Not compatible with some vehicle models.\*Brake squeal may occur due to resonance caused by aging of the rotor, judder, brake dust, rust, weather, etc.\*Some products are not applicable.**Chamfer Cut To Suppress Unpleasant Squealing**If the pad has corners, it will generate unpleasant noises when braking. To prevent this, the corners are cut off (chamfered edges) to minimize unpleasant brake squeal.\*Brake squeal may occur due to resonance caused by aging of the rotor, judder, brake dust, rust, weather, etc.\*Some products are not applicable.**No Extra Quenching Required**Project Mu brake pads are pre-heat treated, and unnecessary materials that are only required during manufacturing are burned off in advance, suppressing the generation of gas that causes fade. After purchase, you can use them with peace of mind by simply breaking them in.\*Brake squeal may occur due to resonance caused by aging of the rotor, judder, brake dust, rust, weather, etc.\*Some products are not applicable.**Strong Backplate To Prevent Distortion**The performance required of a backplate is that it does not warp under the strong pressure of the piston. If it warps, the friction material will peel off and cause a serious accident. Normally, steel is used for backplates, but Project Mu uses steel plates that are 20% stronger than the original to ensure sufficient strength.\*Some products do not qualify.